Pacific V-RTX 4090 Plus (MSI GAMING TRIO & SUPRIM) GPU Water Block

Cautions

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks:

• To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
• Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
• It is strongly recommended to use market-proven pre-mix coolant, such as Thermaltake Coolant 1000, which offers great performance while protecting the entire liquid loop from corrosion.
• Before storing your water cooling components, please clean, rinse, and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup:

• It is strongly recommended to use market-proven pre-mix coolant, such as Thermaltake Coolant 1000, which offers great performance while preventing corrosion in the entire cooling system (copper, brass, nickel, aluminum, and steel).
• Fill the reservoir with coolant and cycle the power on and off several times while the pump pushes the coolant into the loop.
• DO NOT let the pump run dry. If no liquid is entering the pump, turn off your power immediately.
• Fill the reservoir to the top to prevent air from entering the pump.
• If necessary, tilt the system slightly from side to side to bleed the air out of the loop.
• Place paper towels under fittings and joining points to test for leaks.
• Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
• Before starting, flush out your system properly to prevent any coolant or unwanted particles from sticking to your tubes, radiators, and other cooling components.
• Coolant might fade over time.