Thermaltake Flexible Tubing V-Tubler 4T 1/2’’ (13 mm)
Thermaltake introduces the V-Tubler 4T water tubing for custom PC water cooling configurations. Manufactured from medical grade PVC material, the V-Tubler resists twisting and collapse allowing for tighter bends without the kinking that can cause cooling failures or a reduction in system performance. Designed for use with 1/2” barbs and compression fittings, give users better mounting, easier fitting, and ideal flow. Choose from: ID 1/2” or 3/8” to make your system a showcase for all to see with the Thermaltake V-Tubler water tubing.
Tt LCS Certified
“Tt LCS Certified” is the hallmark that ensures first-class performance from the best features and fitment. A certification exclusive to Thermaltake, it sets the benchmark for all true LCS chassis and is applied only to products that meet our stringent design standards for delivering what hardcore enthusiasts demand. The Tt LCS certification is a way for Thermaltake to designate to all power users the chassis which have been tested for best compatibility with extreme liquid cooling configurations.
Medical Grade Construction
Made in Taiwan, the V-Tubler 4T is constructed from
medical grade PVC which
is reliable, non-toxic, and substance free. Smooth inner walls improve closed loop
sanitation, reducing
particular gathering/entrapment onto the tubing wall. Working temperature range from -4℉
(-20℃) to 140℉ (60℃).
- Inner diameter: 1/2” (13 mm)
- Outer diameter: 3/4” (19 mm)
Material of V-Tubler 4T as below:
Remarkable Expansion
Designed for use with 1/2” barbs and compression fittings,
V-Tubler 4T is
pre cut into retail coils of 200cm lengths, allowing enthusiasts to build up
aesthetically-superior water
cooling systems by allocating the radiators to each particular component and incorporating
externally-modular
upgrades for their chassis.
Cautions
Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks:
- To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
- Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
- It is strongly recommended to use market-proven pre-mix coolant, such as Thermaltake Coolant 1000, which offers great performance while protecting the entire liquid loop from corrosion.
- Before storing your water cooling components, please clean, rinse, and dry. This will ensure a longer lifespan for your components.
Thermaltake recommends the following steps to be taken after completing your water loop setup:
- It is strongly recommended to use market-proven pre-mix coolant, such as Thermaltake Coolant 1000, which offers great performance while preventing corrosion in the entire cooling system (copper, brass, nickel, aluminum, and steel).
- Fill the reservoir with coolant and cycle the power on and off several times while the pump pushes the coolant into the loop.
- DO NOT let the pump run dry. If no liquid is entering the pump, turn off your power immediately.
- Fill the reservoir to the top to prevent air from entering the pump.
- If necessary, tilt the system slightly from side to side to bleed the air out of the loop.
- Place paper towels under fittings and joining points to test for leaks.
- Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
- Before starting, flush out your system properly to prevent any coolant or unwanted particles from sticking to your tubes, radiators, and other cooling components.
- Coolant might fade over time.
| P/N | CL-W019-OS00TR-A |
|---|---|
| Color | Transparent |
| Inside Diameter |
1/2”(13 mm ) |
| Outside Diameter |
3/4”(19 mm) |
| Length | 200cm |
| MATERIAL |
PVC |
